1995 GMC Sierra C1500 "95 engine wiring" Questions

...95 gmc sierra wont start when hot starts and works fine when running but when i stop it and go to restart it s hard to start Im guessing it's a 4.3 L engine. Sounds like your coil is acting up when ...

...95 is the same as the 93. On the '93 there is a timing advance wire you have to unplug (brown wire near the distributor on the firewall with a plug connector.) Start it up with the wire unplugged ...

...95 gmc sierra 1500 1] disconnect the positive battery cable. 2] remove the serpentine belt.  you need a socket wrench to remove the tension from the idler arm pulley. 3]disconnect the battery ...

...95 GMC Sierra 350 cu.in. 1995 GMC Sierra P/U with a 350cu.in. Disconnected tan wire with black stripe, timing set at 0' BTC as soon as I reconnect the timing advances 20+ degrees and stays there, ...

...engine stopped . Now im guessing you can't start it and want to know why. If it was hit from behind begining a 95 .Their were wireing problems to the fuel pump with the wires and the connecters . The ...

...95 gmc pu, i,m having problems with the engine all of a sudden shutting down. i have replaced the MAP sensor and a electronic part that goes inside the distributor [don't know what its called] but I ...

...95 S 10 BLAZER WITH A 4.3 ENGINE. ARE THESE COMPATABLE TO SWAP? actually i would say no because there are 6 cyl transmissions with 4 frction plates and v8's have 5 friction plates in the forward ...

95 gm 5.7 stumbles bad at low rpm timing @ 1 btdc new wires,plugs,cap,rotor,IAC,TPS,MAP,temp sensor and fuel filter can unhook vac from MAP richens up stumble gone but to rich to drive.keep getting ...

...95 gmc 5.7 tbi truck Code 44 oxygen sensor detecting lean exhaust HI. This is an indication of a lean mixture as indicated by the oxygen sensor readings. 44 Code The ECM supplies a voltage of about ...

...95 gmc 4x4... sank it underwater. replaced fuel pump assembly, distributer cap, rotor, and spark module,ignition switch, computer, fuel pump relay, plugs, and wires. had only 80 psi compression, so I ...