...TDC). pull #1 spark plug to sit on top of the #1 piston by inserting long screwdriver into the hole. then check the cam to the other end of the motor. there slots on both cams that should be lined up ...
tdc..was told might be the timing compression or just the sensor and the tensioner..any body have any ideas??????? You obviously need to replace your TPS, and you may need a new belt tensioner as well
first piston (close to the timing belt) on the top and the head on position por the TDC and is here that we need to know what car is your and probably we need the Chiltons book!. to set the time again
TDC in Haynes Manual- Isuzu Rodeo TF 1991 I always thought that if changing a blown head gasket,or any engine work, you set all timing marks using No.1 cylinder as your starting point and,once set you
...changing the head gasket on 1991 honda accord explain the TDC sequence TDC is when the #1 piston is at the top of the stroke. I.E. flush with the top of the block. It should also read 'zero' on the ...
Changing head gasket did not mark anything on cam pulley or timing chain how can i be sure timing is correct when i replace the head back on.regards eddie make sure #1 clyinder at TDC(top dead center)
head but now the motor won't start.The timing is fine Help! Need to check these things first Has it got fuel?.......................Is there fuel in the carby bowl? Has it gt a spark?.................
...head gaskets after mounting the two heads i want to time the engine but at TDC the timing mark will not align You need to pull the timing belt off,Line the marks as required,Reinstall timing belt. ...
...head as you look thro the cam drill/hole and when crank pully is at TDC the cog has a marked tooth which should align with mark on engine approx 12-30 pm position these marks are all clear to see and ...
1,302 questions posted
Usually answered in minutes!
2,142 Questions
1,335 Questions
1,118 Questions
841 Questions
627 Questions