Question about Dodge Stratus
...coil blow the ignition switch Not likely to cause the switch to "blow". are you looking for the ignition fuse or relay- they're under the dash or under the hood in the fuse/power distribution
coil check good,change crank sensor.car was running good ,driveing down road and engine started loosing power and stopped Have you had the ignition switch changed? If the ignition switch is faulty you
Question about Pontiac Cars & Trucks
...coil if no power to coil[s] assuming its the ignition coils sheck and test wiring and coil for damage or failure What coil ? ignition coil for spark ? What engine ? 4 cylinder ? Has four ignition ...
Question about Ford Cars & Trucks
...the switch to the coil one provides power to the coil when the starter is engaged and the other keeps power to the coil when the starter not in use and the wire on the start circuit is ...
power to coil I replaced the torque converter now no power to coil. check the crank sensor in the back at the transmission Im assume you tested the coil which is good coil, and no voltage to the coil.
...power to the coil from the ignition switch? Use a 12 volt test light with the clip attached to engine ground. Turn the key on and backprobe the connector terminal with the black wire/red stripe. If ...
...power supply from the ignition switch to the coil then there is a problem from the switch to the coil. It may have a fusible wire inline with it which maybe broken. The next best thing to do is run a ...
...have no power to the coil with ignition switch on ,if you have power then check it with the ignition switch in start position as sometimes the switch packs up and no power to the coil in start ...
Question about Ford Cars & Trucks
...power to ignition coil tested high current fuse panel no power there either 1994 ford Taurus 3.8 fuel injected Ignition switch supply's B+ voltage to ignition coil fuse in the engine compartment fuse ...
where is ignition coil power switch got no spark when crank it, but w/ignition ON got power to coil?? It is powered up by the ignition starter switch. You need to run a fault code test.
949 questions posted
Usually answered in minutes!
1,417 Questions
1,121 Questions
924 Questions
772 Questions
528 Questions