2004 Dodge Caravan "change crank sensor grand" Questions

...grand caravan 2002 wont start changed 2 sensors the throttle position sensor and i a c still wont start help crank sensor-if bad it will not start. IAC and TPS usually only cause drivability

...out camshaft sensor. No engine codes. Where do I start with out changing out 1000.00 $ of parts? Thanks in advance Monty No spark indicates either a coil,distributor,or crank position sensor

Change Alternaor and Belt and tried to started the and it wont turn over.... may have cross spark plug.. The coil pack that the spark plug wires connect too are labeled 1-6 the block if you look at it

...accelerating. changed crank shaft sensor . no check engine light on have you checked the fuel injector? if enough fuel is not getting through when accelerating it could "choke" causing the ...

...It was electrical changed the crank sensor and it ran for 10 min then wouldn't run anymore. Changed the cam sensor and it;s been running for a week. Now the blower only blows on high (not

...dies again pep boys change crank sensor fuel pump no help when eng shutdown middle of high way or trafic no fuel to eng does have elect power no eng check light any help my e-mail is ...

...crank shaft position sensor. I changed it, and it's run fine ever since.  On my van, it was located on the transmission.  One bolt held it in I think.  Had to use a long extension, ...

...crank case. Also, as the cylinders wear and the piston rings get a little sloppy, more gasses escape and it has to go somewhere so they used to dump it into the air again contributing to the smog ...

...CHANGE OUT A CRANK SENSOR IN MY GRAND CHEROKEE. I CAN'T EVEN SEE THIS UNIT ON THE ENGINE AND I CAN BARELY REACH THE THING!!! I NEED TO REPLACE THIS CRANK SENSOR IMEDIATELY!!! Jeep Crank Sensor ...

crank sensor on a 3.4l 2003 pontiac grand am Will the crank pulley have to be pulled in order to get to the sensor? If you need to replace that sensor than yes you need to pull the crank pulley. There