...remove one full-length shim or add one short shim to the outboard pad. A high-pitched whine after the engine is running calls for adding full-length shims one at a time (but no more than four) until ...
...outboard solenoid is mounted. When the ignition switch is turned to the start position, the solenoid armature is drawn in, engaging the starter pinion with the flywheel. When the starter pinion and ...
outboard solenoid is mounted. When the ignition switch is turned to the START position, the solenoid armature is drawn in, engaging the starter pinion with the engine flywheel. When the starter pinion
...Remove the starter motor and if equipped, the shims. To install: Place the starter motor into position. Install the starter motor inboard bolt but do not tighten it at this time. If equipped, install ...
outboard of the water temp sensor and they both share the same wiring harness. The cam sensor is on the passenger side, actually on the transmission bell housing. It takes the signal from the flywheel
...Remove the torque converter/flywheel cover from the bottom of the bell housing. Using the flywheel turning tool, turn the flywheel and examine the flywheel teeth. If damage is evident, the flywheel ...
...Remove the torque converter cover on the bottom of the bell housing. Using the flywheel turning tool, turn the flywheel and examine the flywheel teeth. If damage is evident, the flywheel should be ...
Question about Cars & Trucks
...outboard computer may not be getting correct messages from the inboard computer . Aligned crankshaft & camshaft timing holes & inserted 8mm rods ,locked the flywheel & Replaced crankshaft pulley .Had ...
...outboard 135 hp from 1986 jumps from 1000 rpm to 1400 rpm. It is not the spark plugs or ignition spoils (Have disconnected each once at time and there is no difference) The twoo boxes are changed at ...
1,572 questions posted
Usually answered in minutes!
867 Questions
924 Questions
766 Questions
627 Questions
548 Questions