1999 Dodge Intrepid "cycle engine dies throttle" Questions

...cycle, the engine should be idling normally. * If the engine idle speed has not been learned, turn OFF the ignition for 60 seconds and repeat step 6. 8. Once the engine speed has returned to normal, ...

engine will begin to chuggle, miss, die out, lights on dash on, will not take throttle. I put it in nuetral and cycle the key, it starts right up and i drive away. I dont even stop, i can be going 70.

...engine. Even though I can here the pump cycle when I turn on the key and also as I turn it off. This truck does not list a fuel filter but I am wondering if there is one hidden somewere. My 2005 GMC ...

dies at idle. Removing the throttle body and carefully cleaning these will give the engine enough air to idle. Use a new gasket when re-installing. Remember that electronic pieces on the throttle body

...throttle valve and air bypass valve, it is made by a company called CRC, remove the air intake hose to the engine, hold the idle high so the engine won't stall, then spray the can of cleaner into the ...

...dies when i let off the gas such as going into a turn. Sometimes it even does it when I am coasting down a hill. Sounds like it's your IAC (idel air control sensor).  The IAC is ...

...THROTTLE BODY SIZE OF A D CELL BATTERY WITH A CONNECTOR SET AT A 90DEGREE AT END OF IT. TRY UNPLUGGING IT,ENGINE MAY DIE AND OK. USUALLY NOISE STOPS IF REAL BAD. IF STOPS YOU WILL KNOW FOR SURE THEN. ...

...engine will lope and the idle doesnt stay consistant and eventually dies what would cause this? dirty intake throttle valve and air bypass idle speed control motor. ttry the following. Here is the ...

...engine light comes on right before it dies check IAC motor, or dirty throttle body. P1684 is only a status which indicates that the PCM memory has been cleared within the last 50 ignition cycles and ...

dies when engine is put in park. Engine is warm already. This can be cuased by a sludged up engine throttle valve and automatic idle speed control valve, do the following procedure and this should fix