1997 Dodge Grand Caravan "antifreeze leak back engine" Questions

antifreeze on the back, driver's side. What's wrong? sounds like a water pump, the pump is right there and the most likely thing to leak. I would think a water pump or even a head gasket. A water pump

...back up and replace the thermostat with a new one. Refill the rad and engine by filling the coolant reservoir with a mix of 50% water and 50% antifreeze, or buy the premixed stuff from the auto parts ...

...leak by rear tire,... looks like 2 lines that terminate in this area,..... IF YOU HAVE REAR HEAT AND A/C THERE ARE 2 LINES THAT RUN UNDER CAR ALL THE WAY TO THE BACK PASSENGER SIDE WHEEL WELL!! THEY ...

leak. Van has not overheated, yet, but as soon as water or antifreeze is added, it comes back out in steady stream. i have a 1999 grand caravan and it is smoking under hood with smell of atifreeze but

...antifreeze, be sure to get air out of system before closing it back up also test the radiator cap to be sure it's not leaking. and you should be good to go. ive read the advice given and say yes its ...

...leak somewhere) my hubby put in a new thermostat, it starts knocking and sputtering loosing power, over heats then cuts off. I let it sit for 20 mins and it will finally start back up. It only over ...

...antifreeze. put top back on and it should be fine. if not repeat. also check the valve is working and not blocked on the control for water direction will be electric type or vacuum type electric type ...

...back a little before the "H" position, the higher the speed of the car (like on the highway). Could it be a faulty thermostat? HAS THE COOLANT BEEN CHANGED RECENTLY IF IT HAS ITS POSSIBLE THAT IT HAS ...

...back down. Is it likely the coolant sensor? 3.3l No leaks, no smell. Runs strong while in drive, won't rev past 3000 in neutral. Could be.. is the system FULL? Air in it can cause some odd things. ...

...back on then tighten the pulley bolts Again medium tight is fine, no locktite needed you're done, it'll take a novice about two hours NOTES You bolt the pulley on first and you can't reach the pump ...