2001 Chevrolet Blazer "starter engage flywheel" Questions

...You can either try changing the mount end of the starter with the old one, (if it didn't have the same problem) or using shims between the starter and block to get the starter to properly

...starter, it's the gear that engages with the flywheel gear. It is a one way clutch, it is supposed to hold when the starter is turning the engine. But, freewheel when the engine starts so it doesn't ...

...engage the flywheel. If I understand you right, it sounds like the starter solenoid went bad and could possibly work again when the engine cooled down. The other scenario is that the ignition switch ...

...starter gear is not advancing on the shaft to engage with the flywheel to crank the engine over. Did you replace the starter and solenoid (they usually are sold as a unit), or did you just change the ...

...starter or flywheel. Worn or missing gear teeth in starter or flywheel. Starter not engaging correctly. The alarm does not work correctly for any of these reasons. It sounds like it's time for a ...

...starter motor with the flywheel/flexplate it is also possible the gear on the starter is loose or broken. Either way remove starte and bench test applying voltage to battery terminal and ground to ...

...engage, but not getting enough power to do so. You may want to check your battery cables to make sure they're tight. Before doing this disconnect the battery cables make sure the clamps are clean. ...

...flywheel teeth that the starter engages to to spin the engine over.. And you'll see bolts holding the torque converter to the flywheel. You need to remove one bolt.... Turn the engine over by hand at ...

...starter fires but won't engage flywheel. it is a brand new starter 1965 mustang starter fires but won't engage flywheel. it is a brand new starter Doesn't matter. The forks inside the ...

...engage the starter, the bendix is not fully engaging the flywheel and you are hearing the teeth of the starter grind against the flywheel. If this keeps up, then you will have to replace the starter ...