2004 BMW 3 Series "bank sensor" Questions

Bank 1 O2 sensor swaped with Bank 2 O2 sensor I have an 04 325i and the engine went. I replaced it with a 2002 325i engine. I didn't replace computer. The check engine light is on and says that bank 1

...sensor, bank 2 what is the location of the oxygen sensor, bank 2 sensor 1 for 2004 325I Its located in the exhaust manifold on the passenger side,its the sensor closest to the rear of the

...sensor bank 1 (exhaust). I replaced it and cleared the code. However, I drove it and the check engine light stayed off, until I turned the car off, then turned the car back on and it went on again. i ...

...sensor bank 2 , sensor #1 That's usually a problem with the primary (pre-catalyst) O2 sensors. It can be a fault of the mass airflow sensor as well, but typically the O2 sensors are to blame, as ...

...Bank 1 Sensor 1) p1189: Fuel Control (Bank 2 Sensor 1) p0171 and p0173: These are very common codes on BMW's which can also be false codes, try clearing the codes and run the test again they may not ...

sensor in bank 1 detected a lean condition (too much oxygen in the exhaust). On V6/V8/V10 engines, Bank 1 is the side of the engine that has cylinder #1.Note: This DTC is very similar to P0174, and in

...bank 2 aren't getting enough fuel. This is an indication that an O2 sensor noticed that there is too much oxygen exiting the engine into the exhaust system. Read more at: ...

...Bank 2 Sensor 1 217 - Serial Communication Link The 217 code indicates the communication bus between two or more of your computers is malfunctioning. The 155 code is one of your rear oxygen sensors ...

P1062 what does this code mean P1062 Bank 2 sensor 3 [HOS2] .

fix this problem...Any help greatly appreciated...thank P1520-This Relates to "B" Camshaft Position Actuator Bank 1 Replace CPS Exhaust sensor and drive it for a few hundred miles. Code should go away