2001 BMW 330 "dash brake light stays 1994" Questions

...Brake Lights are stuck on....the ABS comes on the dash intermittantly, could this be 2 seperate things? Brake Light switch and the ABS Sensor(s)? Any Advice? CHECK YOUR FUSES I HAD ONE WITH A BLOWN ...

...brake light on the dash board stay on after brake release is pulled the brake light on the dash board came on today. i pulled the release brake and it continued to stay on.i brake ok..what do i need ...

...dash there is a switch that when you push the brake pedal, a pin extends to complete the circuit. There should be a bracket with a rubber tab on it attached to the pedal lever itself. If the rubber ...

...brake dash light stays illuminated following a hard brake incident. The light disappears when the brakes are applied and then remains lit after brakes are released. just a little bit low on brake ...

brake lights are connected to a button that is adjustable on the upper end of the brake pedal, under the dash.  check and adjust the button so it is only activated when the brake is pressed. 

...dash goes on and stays on all the the after touching the brake pedal. the brakelights are all working any ideas ? Look to see if the brake fluid in the master cylinder reservoir is low. The light is ...

...dash at the top of the arm that the brake pedal is mounted to. It either needs to be adjusted or is faulty. This switch is what makes your brake lights come on and it will do this whether the car is ...

...dash board stays on and will not go off. Recently my break lights will stay on even when the car is off a theirs no on in the car. is your e-brake on? Brake light switch that is attached to the brake ...

...and stay on? Make sure the brake light switch is not defective, is adjusted correctly and is tight. It is under the dash and the brake pedal arm pushes it to the off position when you release the ...

...OFF, IT IS A 93 COROLLA check to be sure the brake light switch under the dash on top of the brake pedal arm is disconnecting, see if unplugging that switch does the trick, if so , replace the ...