2006 Pontiac Grand Prix "using bleeder valve thermostat housing" Questions

...Using an 8mm socket or end wrench open the bleeder valves, this will force any air out of the cooling system as the engine heats up. When a steady stream of coolant starts to come out of the bleeder ...

bleeder valve on thermostat housing what does it do? IF you replace all the coolant, you use that to get the air out of the system..

...bleeder valve located on top of housing. youalso want to make sure you opn bleeder valve while adding coolant till nothing but coolant,not air is coming out of it then close it. this lets all air ...

where is this bleeder valve? Usually 2--1 on thermostat housing and 1 on lower intake manifold--left of center--note 4' of .250 clear hose used on bleeder to route any coolant away from drive belts.

...the fan. In most cases, the ecu turns the fan on and off, not a thermoswitch. Manufacturers have stopped using those switches. If there is a bleeder valve, it is probably on the thermostat

...bleeder location-3.3L engine Be sure to refill the cooling using the proper grade and type engine coolant. Start the engine and check for leaks. Start the engine and allow it to reach operation ...

...bleeder valve on thermostat housing. And if it is do I need to bleed the air out here? no you do not have to bleed it and yes it it is a bleeder no need to use it though i change coolants every day ...

...bleeder valves, where and how to use there should be a fittingon the thermostat housing.open it,open radiator cap run engine.when you get good flow coming through the fitting closethe fitting replace ...

00Linc ls v8 engine coolant fill cap is that used to bleed air blockage You should have a block bleeder valve located around or in the thermostat housing.

...using a pressure testing tool (available at most auto parts stores). Use the pressure shown on your radiator cap. Most cars are 16 PSI or less, so don't exceed that pressure. Replace the radiator cap ...