2006 Mazda 6 "wiring" Questions

I installed HID lights that I purchased from here. http://www.wholesalexenonhid.com/ they work great however when wired I had to connect the postive wire to the factory bulb connector as it only has ...

IAT and MAF info Hello, I bougt a performance chip for my 2005 mazda6. Directions say to use it to bypass the IAT sensor with it. My IAT sensor is in the clip with the MAF sensor. What wires control ...

wiring i need the wiring diagram for mazda 6 ,2004 for a alarm that im installing Autozone.com does have the wiring diagrams for your vehicle.Just as a warning as I don't know the level of your skills

headlight wont come on got it replaced & still wont come on also turn signal wont come on either look at the ground wire that goes to the lights that wire is a shared wire

Power trunk not activating. The power trunk solenoid will not activate during normal use. It does not matter whether I use the button on the dash or the key fob, nothing works. I cannot find any ...

...wire not in the picture, black with yellow tracer. on the hinge side of driver door is usually a wiring harness going into the driver door, probably has a protective covering, move cover back far ...

...FOR A DRIVE N THE AT LIGHT N AIR BAG LIGHT WERE ON N WHEN I PUT IT ON REVERSE IT SHAKES COULD THE WIRING HAVE NETHING TO DO WITH THIS??? Only way to find out is to undo the wiring and see if the ...

Spark plug wire diagram for 2005 mazda 6 2.3L 4 cylinder? After removing the plastic engine cover, look at the top of the ignition coil. It should be numbered 1 through 4. This is plug number 1 on the

when i press my brakes my dash lights go out check around the brake pedal for any wires pulled for the pedal also check the brake swich and the wires for posible short if you install a new alarm ...

rough idle when wet when its damp the engine runs rough, sounds like its not running on all cylinders then the engine management light comes on. When the damp conditions go the engine runs fine. Go to