...relay was replaced as they went faulty causing intermittent starting and on my passat and many out there, there is a common problem with corroded wires in the footwell(passenger side in europe) where ...
...the relay a rap or drop on ground,sometimes tyhat will un-weld contacts and replug in and see if it works again,if it does get a new relay cause most likely it will weld again later(contacts are
Question about Volkswagen Passat
...91 Bronco, why do the headlights only operate on high beam? Stuck or "welded" points in the dimming relay. Rebuild, or replace the dimming relay. Find by traceing headlight wire back to the dimming ...
...I TAKE THE KEY OUT I UNHOOKED THE STEERING WHEEL AND IT STILL HAS POWER WITH NO KEY The key runs a relay. The relay is welded in the on position. Start pulling out relays until you find the one that ...
weld it self until it happens again. It's your turn signal relay. For sure. the only problem is that the turn signal relay is located inside the hazard light switch, and it has a loose welding probles
...on running and it My radiator cooling fan keeps on running and it won't stop until my battery dies. What could the problem be? sounds like a stuck relay, relays can sometimes weld themselves ...
after welding a support braket to my frame, my after welding a support braket to my frame, my coolant fan, and my switch that lets me take my car out of park seems to no longer be workig. i ...
Question about Volkswagen Passat
...starter solenoid, the contacts may be welded in it. I am not sure if the Ford Ranger has a starter relay also in the fuse box. If the starter solenoid is good then it could be the starter relay has ...
...not stop i must unplug the harness to stop them you could either have a welded contact at the wiper relay or the shorted wiper switch. after you unplug the harness, check the relay, remove again the ...
Question about Volkswagen Passat
...i start the car it just started doing it what do you think it could be Try removing the cooling fan relay.If this turns the fan off,you could try swapping the relay with another to see if the relay ...
1,270 questions posted
Usually answered in minutes!
1,322 Questions
1,089 Questions
844 Questions
677 Questions
496 Questions