Question about Volkswagen Jetta
...Engine light came on showing a p0480 code, which could be a defective cooling fan relay or wiring. Located under hood just below the coolant reservoir. remove nut and ground (not required but makes ...
...to the radiator core support. There are some philips head screws that hold the 2 halves of the engine cover over the filter, you have to access the underside of the engine cover to get to
...2.0 liter engine? Hi!! Firing order is 1 - 3 - 4 - 2, distributor rotates counter clockwise. A HELPFUL Rating would be greatly appreciated. Thank you for using FixYa 1995 Volkswagen Jetta III 2.0 ...
engine is hot, feel the 2 main rubber hoses on the radiator at the front of the car, if one of the hoses is cold or there abouts, then this is most likely ur problem. locate and remove the thermostat,
...engine cover off my 2.5L, 5 CYL. SO I CAN ACCESS THEBRAKE FLUID HOLDER if your talking about the engine cover it is just pushed on on rubber mountings so remove dipstick and lift up normally three ...
engine cover on my 2007 volkswagon jetta and where is the air filter?? 1. Unplug the Mass Air Flow (MAF) sensor. 2. Undo the spring clips and pull out the turbo inlet connector. 3. Remove the two T-25
Question about Volkswagen Jetta
...2. Using a full function VW compatible scan tool enter 01 engine management. From there, select basic settings enter block 060. This sets the throttle body adaptation. 3. Start the engine and using ...
...engine. 5. Remove the bolts (1) from A/C compressor and disconnect refrigerant lines. 6. Remove hex screws (2) and remove the compressor. Reinstall in reverse order making sure the bushings (3) are ...
...engine mounting bolt. If the starter tests OK, then it may be option 2 or 3 (above). If the car is an automatic, try cranking it in "N". This will tell you if there is any sort of starter interlock ...
1,254 questions posted
Usually answered in minutes!
1,072 Questions
1,150 Questions
968 Questions
1,003 Questions
917 Questions