2005 Pontiac Vibe "put new license plate light" Questions

...put INSIDE the shaft of each and twist against the parts that are made to allow this.  SUPER easy when you do it this way instead of trying to use your hand or a wrench or something.  this ...

new bulb in its retainer and ensure it is in place. Tip: Refer to your car's user manual to determine the correct type of light bulb to get for your specific vehicle. Step 2: Complete the installation

...plate lights wont come on new bulbs have been put in Pull the bulbs and check to see if you have voltage going to the socket. If not, check wiring, and check for sany damage to wiring, harnesses,

put on a new bumper and it comes with two new license plate lights, each with a red and black wire. Where do I hook up these wires? I have a 1990 Toyota truck (22RE engine, 4WD) Hi,you should have the

...put 2 new bulbs in all other lights work but licence plate lights im wondering if there is fuse The licence plate lamps are tied to your tail lamp fuse on most models. Might be a bad ground. yes on ...

...new 2006 audi tt and can't get them off. any help would be appreciated. The manual says switch off the lights and disconnect the battery. Then "Open trunk lid. Press and slide license plate light ...

...license plate, LOOK UP and you should see the bulb and whatever encasing is there. Mine is in a tube and it is attached with (2) mini bolts that will need to come out first, then it just looks like a ...

...new license plate assembly to the bumper cover, using the same screw holes or fasteners. 9. **Reattach the Bumper Cover:** - Align the bumper cover properly, and carefully push it back into place, ...

...and dash lights. brake lights, back up lights, turn signals, and flashers work. replaced blown fuse, put in new tail light bulbs. How do I fix this. Need help, asap probable short in headlight ...

...hand up into the bumper where the caseing is and you will turn the socket counter clock wise and it will slide out. pull the bulb out and put the new one in and put the bulb socket back in the ...