2006 Nissan Maxima "fix stuck fuel stop screw" Questions

fix. Well that's how long it took me to reapair my 2006 SL. First remove the 3 screws from the shroud around your column they are under your column. Make sure your column is extended and in its lowest

...fuel vapor comes out) then screwing cap back on. Cannisters clogged?Other suggestions?thanks-marshall not sure how that could be the cause, but check to see if vent valve is stuck closed. Otherwise, ...

...fuel problem, automatoc choke stuck? Just over a week ago i bought a 1993 L plate nissan micra. but the idiot that had it before ran the petrol that low there is all **** getting stuck in the ...

fix the problem? the motor is a ford 460 Electric fuel pump most likely has too much pressure for the carb. AFAIK, the Holley 4150/60 & 4165/75 should each demand the usual 4.7-5.3 PSI (4.7 @ idle

...stuck open or a leaking fuel press regulator which is under the upper plenum i would check the valve first just remove the valve it should be visibly open if thats your problem. Thanks for contacting ...

stuck open. (this to is a vacaum leak ) clean it.
2: someone played with the idle stop screw, (never do that)
3: if car has obd2 fuel injection, does it? then scan it, see if ECT reads 180f+, if

...stuck/dead IACV might prevent the engine from starting. If so it can usually be fixed by simply cleaning it. Cleaning and inspecting the throttle body and the IACV is probably a good idea anyway. And ...

...fix that problem. It was a leak on the Thermostat wall. After that the heater never work anymore. Now after few week, the engine die on me while going up the bridge. I don't know if anything has ...

...stuck in traffic idling at that high rpm.. for a brief brief time the idle went back to normal (days ago now) and stayed normal for about 50kms of driving during this time it did not overheat and was ...

...stuck in them s well, this is usually just a easy fix,clamp the rubber fuel line before the pump, undo the switch, clean it and refit it, then undo the clamp and prime the pump using the hand primer. ...