2002 Nissan Xterra "rod gas level" Questions

...gas pedal, still runs fine tho. oil level is good. im thinking its a rod knock but not sure... ????????? Listen to the engine, if the noise is down low it is rod if it is up high it is valves. IF it ...

gas level correctly Two things, 1 they could have bent the rod for the level. 2 In some tanks you can put the sending unit in the wrong direction, this may set the float on top of a ridge in the tank,

gas maybe the tank level sensor is shot. I use what pilots do , i rod dip the tank, (home made dip stick) see if it is 1/4 full first. a rod that can not break off into the tank. I use an electricians

...gas, there was a sound and she could "feel" it when she accelerated. The car is a 2003 Buick Rendezvous with 79000 miles. SOUND LIKE PISTON RODS.LOW OIL LEVEL OR FAULTY OIL PUMP.DUE TO LACK OF OIL TO ...

...gas....Does it still knock? A rod knock means you need to rebuild that motor. A rod knock can usually happen from beating on the car or a timing belt slipped a couple of gears. I would check your ...

...gas had anything to do with it, because it has been acting strange for a couple of weeks. Checked the oil level, fine, checked the coolant level, fine also. It knocks as soon as the car is started or ...

new carb on it and it floods out and leaking gas where rod goes through blow Remove the air horn and check the float level. Also check the needle and seat for particles causing it not to seal properly

...gas. Hello, this could be a very big problem. I would first off and check that your oil level is fine. Next, the bearings on your rods or rod bearings may have been "thrown" causing this internal ...

...idle. What could it be? too low fuel octang, poor quality gas, or contaminated fuel, check fuel and igniton systems. Worn cam/crank/rod bearings, wristpins. Low oil pressure, so check your oil

...1998 buick century is knocking, oil level is good and the knock gets louder when pressing the gas it sounds like the connecting rod bearings on the piston or the mainbearing has spun on the crank ...