2002 Nissan Xterra "area triangular" Questions

...triangular piece of plastic that simply popped off, covering the mirror attachment area. That now appears to not be the case, and it seems that the door panel is all one piece. I have attempted to ...

...it. It is currently quite loose hanging on to the mounting on the door. Many thanks. you need to take door trim off door and a triangular peice of to ge to the bolts area usually a #10 mm just ...

...area to expose wiring and mounting bolts but if its apart of door panel u have to remove panel most cars and trucks allow u to sneak that triangular plastic piece out with panel on should be 1 screw ...

...area, charging me $80.00 and came up with nothing. Upon my further investigation, I discovered that there is a drain built into the rubber seal at the top of the windshield, in the corner where the ...

...area- a small flat screwdriver or a special clip-remover tool is handy. 3) Raise the hood up. 4) There may be a triangular-shaped hard foam sound damper at the left side nearby the hood hinge...pull ...

...triangular) behind the rear passengers door. In daylight sit inside and get someone with a hose to spray lots of water in that area. If you see any water in the inside try to trace to source. If you ...

...area housing the arm mechanism. I had the same problem and found the problem to be in the arm assembly box on the firewall. Under the hood, triangular shaped box with snap on top was full of dirt, ...

triangular cover over the area of the mirror you will need to remove that cover as well. In the door cover there should be 4 to 6 screws that must be removed then the cover is pryed off. Be careful as

area, driver side, under dash, driver side of brake pedal, mounted on support bracket. Hope helps. Hi there joesdad57! The flasher relay is typically in the drivers side kicker panel. This panel is to

...area- a small flat screwdriver or a special clip-remover tool is handy. 3) Raise the hood up. 4) There may be a triangular-shaped hard foam sound damper at the left side nearby the hood hinge...pull ...