2000 Mazda MPV "light sensor" Questions

Ad

...light indicated a bad sensor 1, bank 2 code (I think). I had my mechanic replace the sensor that was indicated as faulty... cost = $191. Then the Check Engine light came on again (with a different ...

Ad

...SENSOR. Disconnect the battery to reset the system and turn off check engine light. Otherwise you will need a scan tool to look at the voltages being supplied to/from the PCM for each of the Heated ...

Ad

...sensor unplugged battery but engine light still popping back on. took back to shop and they said it now shows no codes all clear. how can i reset so light will go off? Pull the battery for 5 minutes. ...

Question about Mazda MPV

2 Answers

light will flash a number of times to reveal the code. If your model has this, then you dont need to buy the diagnostic reader. Once you know the code...then just change the sensor, and disconnect the

...light came back on one sensor was bad but i decided to replace all but it shows that one is bad . Had it replaced again but the light came back on again oxygen sensors are only indicatores of oxygen ...

...light off? Have you tested power from coil packs or distributor? A camshaft position sensor can cause this as well but most likely the check/service engine light would be on if there was a bad

...When you turn off the ignition and open a door the courtesy signal beeps continually. The lights are off I am not sure why it is doing this. Also as a result the lights do not blink when

...light came on because the on-board computer system has seen a fault with one of the sensor on the car, it could be about any of the 70 plus sensors, you will need to have the codes retrieved you can ...

Question about Mazda MPV

1 Answer

...light comes on and the po 421 01/01 is the code that comes up the p0421 code on this vehicle is either caused by a bad catalytic converter or an oxygen sensor. your mechanic has a scan tool that he ...

Question about Mazda MPV

1 Answer

...light is on. code po106 but i have allready change the map sensor. what else could be wrong p0106 is barometric sensor code and is caused by a faulty egr boost sensor, egr boost sensor solinoid, or ...

Not finding what you are looking for?
2000 Mazda MPV Logo

1,069 questions posted

Ask a Question

Usually answered in minutes!

Popular Products

2001 Mazda MPV
2001 Mazda MPV

458 Questions

2003 Mazda MPV
2003 Mazda MPV

413 Questions

2004 Mazda MPV
2004 Mazda MPV

309 Questions

2002 Mazda MPV
2002 Mazda MPV

262 Questions

1997 Mazda MPV
1997 Mazda MPV

128 Questions

Top Mazda Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

Arnie Burke
Arnie Burke

Level 3 Expert

7339 Answers

Are you a Mazda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...