...the middle one on the rear bank which is closest to the firewall. You'll need to take off the top intake to get to it. Intake manifold gasket. A leak at the intake's port for cylinder 2-between the ...
...it is in most cases the idle speed control air-bypass valve and or throttle valve and upper intake, these area's get full of gunk and combustion residue over the miles and cause idle issues ...
Air intake tube? I was having similiar problems and took the van into to a mechanic. He tells me that the Air intake Tube needs to be replaced and is causing the fuel to run lean...? Looking online, ...
...Sensor/Barometric Pressure Sensor measures the rise and fall of the air pressure inside the Intake Manifold. This provides critical data needed for the Power Train Control Module (PCM) to ...
SYSTEM TOO LEAN BANK 1 look for vacuum leaks (hoses, or intake gasket) by using a throttle body cleaner or intake cleaner and spray in the area around the hoses, and the intake on that side (side one ...
VALVE CLEARANCE WHAT IS THE INTAKE AND EXHAUST VALVE CLEARANCE OF MAZDA BONGO FRIENDEE 1995? I USE 0.04MM IN INTAKE AND 0.08MM IN EXHAUST VALVE
mazda mpv 2000 WHERE IS LOCATION THE P1512-IMRC-BANK 1 STUCK STUCK,AND P1250, Possible problem is carbon build up in intake runners..remove top intake and clean runners..
I got three error code for my Mazda MPV P1518,P1520,P0306. P1518- Intake manifold runner control fault- stuck open p1520-intake manifold runner control fault p0306-cylinder 6 misfire detected good ...
1994 mpv 3.0 torque specs intake Torque Specs : Intake manifold bolts...72-105 in/lbs or 6-9 ft/lbs EGR valve bolts........165-225 in/lbs or 14-19 ft/lbs Remaining little bolts for brackets, ...
how do i fix p 1518 well its your intake manfold there is a air intake sensor it a silaniod should mount to the side of where the breather hose end replace that air sensor and check the wiring to it
1,069 questions posted
Usually answered in minutes!
458 Questions
413 Questions
309 Questions
262 Questions
128 Questions