2002 GMC Sonoma Extended Cab "starter removal" Questions

...starter mounting bolt, then tighten all mounting fasteners to 32 ft. lbs. (43 Nm). Engage the wiring to the solenoid as noted during removal. On the 2.2L engine, install the brace rod and tighten the ...

how to remove starter Disconnect the negative battery terminal, remove the to bolts holding the starter to the engine block, remove the small starter signal wire and remove the battery cable on the ...

1999 GMC sonoma starte installation how to replace 1999 gmc starter because wires are hard to get to. 2.2L Engine remove protective shields as needed then remove front exhaust pipe. Remove the brace ...

...starter for 2000 GMC Sonoma. This is a 4 cyl 2 wheel drive pick-up e Removal & Installation 2-Wheel Drive - 2.2L Engine Remove or disconnect the following: Negative battery cable Front exhaust ...

How to change my starter on a 1999 Chevy P10 Step Van Remove the negative cable from the battery. Remove wires off of starter. Remove 2 starter bolts. Reuse shims that may be installed. Replace the ...

How hard is it to put a new starter on a 2002 Gmc Sonoma The procedure to replace a starter is given below: Disconnect negative (black) battery cable. Jack up the Truck on stands. Remove front right ...

removal of starter 1995 sonoma have removed the two bolts starter is lose but want pull down if you removed the positive cable and solenoid wires. look for a bracket. some times starter has a bracket ...

starter motor how do i remove starter from 91 gmc sonoma pickup 4x4 4.3 lt engine It's easy, 2 9/16 bolts, remember to disconnect battery and make a note of the wiring on the starter. there is bushing

trying to remove starter from 96 GMC Sonoma SLS. Have removed exhaust from manifold but still unable to get starter out from under vehicle There are vehicles that you have to take the motor mounts off

replacing starter for gmc sonoma You will need to remove the motor mounts and jack up the engine and remove the passenger side tire to be able to get it out. the starter is only 2 bolts. Not hard just