1996 Chevrolet Impala SS "oil senser looks" Questions

oil in the plug hole and crank it again if the pressure picks up lot it might start if you do the same to all the cyclinders and then with it all put back together start it. (It'll smoke like crazy so

Hi, can someone tell me where to find the oil-pression sensor on the mb E220 CDI 2001? Thanks I'm not familiar with your car but oil pressure sensers are always put in the block of the engine in an ...

...tell you a lot there. If there is smoke out the tailpipe most likely the oil rings are gone.Or pull the spark plugs and see if there oil soaked. Oil on the oxygen senser can trip the light to come

...oil was changed. It all looks well with the wiring, consider changing the sending unit. Hope this helps! need to check with a manual gage, you could have a wire chaffed or a loose conection on your ...

...oil pump belt, crank senser, map senser, R & R senser. The timing belt was not broke but did have a few missing teeth. It will start and run just fine on a cold motor. After the motor warms up it has ...

oil senser on my 1995 camaro and replace it.? The low oil light is on and i have the level full and I run at least 70 pounds of oil pressure on the gauge. I want to replace the censer before I sell it

...senser has gone wrong on my ford ranger 2.5 td 2002 just need to know where to find it and if its a hard or easey job I believe it is on the left front of the engine behind the oil pump pulley. Ford ...

senser and connect a pressure gauge ( leave the snser plugged in and grounded) If the pressure goes any higher than 5 Lbs. reving it or anytime then you looking for a clog. A good system revved up and

oil change. I replaced one set of coils. But now after all that, the light is still blinking and it doesnt smell like gas anymore. We hooked it up to the machine and it told us it was still missfiring

...oil in the hose and air senser blow back from eng. there should be a silver looking piece at the other end of the hose that goes to valve cover,this is like a check valve, change this piece and u ...