3400 in a Buick Rendzvous correct? Or a 3.4 overhead cam V6 engine in something other than a Rendezvous? Would check the plenum to make sure it did not get cracked when the injector was changed due to
3400 engine upper intake torque spec. and tighten sequence on upper intake starting at the middle bolt and go directly across then criss cross the pattern like you would tightening wheel nuts, towards
...3400 Engine Need Torque Specs for, Head Bolts, Rocker arm bolts, and Intake bolts. Thank You Head Bolts Step one 37 ft lbs then tignten 120 degrees more Rocker arms Step one 11 ft lbs then tighten 90 ...
Question about Buick Rendezvous
...3400 engine what is the torque of the rocker arms 14 ft/lbs first pass on all then an additional 30 degrees for all on final pass ..by the way 1 bolt flat to the next bolt flat is 60 degrees so all ...
...intake gaskets and need the torque specs. for the rockers 2002 pontiac aztek 3400 89 inch pounds then 30 degrees. make sure the push rods get put back in same place they came out they are different ...
Question about Pontiac Cars & Trucks
...3400 sfi engine in it how hard is it to change the intake gasket and what all has to be done Mechanics Job Lots of videos regarding intake manifold jobs on youtube, probably one or more covering that ...
...3400 engine I had a similar problem. 1999 TrailBlazer (found in books and located as an (S-10Blazer). Believe it or not the problem may be in the driver's side door. There is a motor/switch/lock ...
...3400 RPM 145 N.m 106.9 lb ft Cylinder Bore Diameter 79 mm 3.1 in Out of Round - Maximum 0.0065 mm 0.00025 in Taper - Maximum 0.0065 mm 0.00025 in Piston MITCHELL 1 ARTICLE - 2004 ENGINE Engine ...
...3400 or 3800? they both have intake gasket problems. If it is the 3800 supercharged, the blower gasket will also likely be shrunk up. Neither engine is for the faint of heart, and the repair takes a ...
1,233 questions posted
Usually answered in minutes!
1,091 Questions
597 Questions
481 Questions
276 Questions
88 Questions