...oil pan with engine off for about 10 minutes then check oil. If you stop and then immediately u check the oil, oil level will show low, because some oil is at the cylinder head. I think the oil seals ...
...oil pan to help prevent this. they quoted me $500 but thats probably a little rediculous, i dont know, havent researched it yet. but there ya go :) Its normal for rotary cars. Its condensation. Look ...
...stuck teplace reinstall unit new filter and transmission fluid clean pan and do the complete service on it me gaskets and filter and transmission oil and see is that don't take care of your ...
...to a mazda dealership and the will install baffles into your oil pan or a new one that is updated to help prevent this because they redesigned it after 05. water man water, you may have a cracked ...
...oil pan gasket seal was changed due to oil leak from it. Mazda did a compression test on it and it failed in both chambers. Mazda refused to honor the extended powertrain warrenty due to exterior and ...
...oil pan is rusted and all the pipes as well Hmmm. Did "they check it with an OBD-II code reader. If the MIL is on the system needs to have the trouble codes read. If "they" can't do it you can take ...
oil pan on a 1997 gmc jimmy 4x4? 4WD To Remove: Remove or disconnect the following: Negative battery cable Oil level indicator Front differential assembly Starter Transmission cover Oil pan drain plug
...oil pan bolts from front and sides only. 4. Loosen the rear oil pan bolts approximately four turns. 5. Lightly tap the oil pan with a rubber mallet or pry to drain the fluid from main case. 6. Remove ...
oil pan. Remove the oil pan drain plug. Remove the oil pan bolts. Remove the oil pan. Remove the gasket. Remove the magnet. Remove the oil filter. Remove the filter neck seal. The transmission oil pan
254 questions posted
Usually answered in minutes!
583 Questions
26 Questions
12 Questions
6 Questions
21 Questions