2007 Honda Ridgeline "hole rear pumpkin" Questions

rear axle. It is in the center of the axle. Now locate the two caps. The upper cap is for filling, the lower for draining. FIRST - loosen & remove the upper cap...just in case. Second, place a oil

...hole leak in rear differential fluid i have a small pin hole leak in lower half of my rear differential. It looks like someting has hit it cuasing a small dent in the pumpkin. can this be patched. I ...

Hole in rear housing(pumpkin) with some sort of rod also pushed out of pumpkin It sounds like the retaining bolt broke and allowed the spider gear retaining pin to work itself out. Sorry, that rear ...

rear pumpkin cover. Remove this plug and put your small finger in if you can't touch the fluid it is low. Usually a 90 weight gear oil but check your mnfg. specs. This will come in a gallon jug with a

...rear pumpkin until the 75W - 90 synthetic gear lube just barely seeps out the fill hole. Wipe any metal shavings off the fill plug. Insert the fill plug in the hole and snug it up, not to tight, just ...

...rear differential. Then just remove the bolts from the cover plate and get a gentle tug to get it off.Clean the old gasket off both the cover plate and the pumpkin itself. I like to spray a ...

...rear differential. from hole near top of housing (pumpkin). What is this is this supposed to be there? ITS A VENT ITS LIKELY BEEN OVER FILLED ITS 85 -90 WIGHT OIL AND EXPANDS A LOT IN HIGHER TEMPS IT ...

...rear of the pumpkin, If not and its Mechanical replace the gear in the transmission, check and see if the end that goes into the speedo is warn, cable should be replaced...check to see if the cable ...

...rear ,or the sometimes called pumpkin.There should be a plug that you have to unscrew .sometimes its a 3/8 drive that's the size in the center of the plug.Once opened you could stick your pinkie in ...

rear end fluid take the plug out of the rearend housing (pumpkin) with a ratchet. Put your finger in the hole, oil should be within a 1/4" from the bottom of the hole, if not, add the proper grease in