2008 Dodge Nitro "engine timing" Questions

...timing belt on a 2008 Dodge Nitro and is it an interferance or non-interferance engine? forget what the makers say re belt change GET IT DONE EVERY 60K (you will soon find out if its an interferance ...

2007 dodge nitro AC will only work after engine heats up the AC will not start unless the engine is warm. The AC compressor will come on for a second then shut off about 3-4 times then nothing until ...

...and the transmission. You can improve the fuel consumption by checking these points.Hope the engine scheduled services were done on time and the compression is good,no smoke or oil

...with a 2.8 Diesel engine. I've just ahd t change the timing belt, how d I set the timing correctly ?

...more of the following may be the cause: 1. One of the cylinders is not firing properly, causing the engine to shake, which is more noticable at idle speeds. This is unlikely to be the cause though, ...

...timing belt is inside the engine and should not need replacing unless the engine is running REAL bad.If you are talking about the serpentine belt,a rubber belt which the engine drives and it powers ...

Check Engine light keeps going on. What could be the problem? Check engine light keeps going on. What could be the problem? make sure gas acp is on tight this is a 80% problem most of the time drive ...

...should be under warranty, take it back to the dealer. Sounds like your losing the fuel prim to the engine. Before starting it turn the key's to the accessory for about 5 sec before starting it and ...

...Scanned the computer in order to know what fault codes is stored there;The Four Most Common Check Engine Light Scenarios and What to Do:* The Check Engine Light turns on and off or flickers.If the ...

heater problems 2009 dodge nitro v6. engine temp good but no heat.removed hoses from heater core and flushed core. had great heat for 1 week then nothing again. flushed core again had heat for 2 days ...