...3-4 times then nothing until the engine heats up and then nit will run great. The system has been evacuated , Evap and expansion valve replace and recharged after 3 45 minute vacuum cycles clutch ...
which cylinder is number 3 on 3.7 liter engine Number 3 is located on the rear of the engine passenger side on the rear wheel drive model.
...on 2008 Dodge Nitro Same as above unscrew the old filter, lube the rubber O ring seal of the new one with engine oil and install, tighten 3/4 of a turn from when it contacts sealing surface of
3. An engine mount has weakened or torn loose. Your engine isn't attached to the car with solid bolts. There are special pieces of rubber in the place where it attaches, and these can erode over time
...3.7 and today my engine light came on and it was running like I was on rumble strips. I floored it and it sputtered and ran terrible then the light started flashing then I cut it off tried to reset ...
Where is the thermostat located on a 4.0 2008 Dodge Nitro R/T ? It's on the front of the engine, #3 and 4 in the picture http://i1198.photobucket.com/albums/aa448/Wrenchtech/158333050.jpg[/IMG]
Question about Dodge Nitro
I have a 09 dodge nitro it has 3 coil wires can you give me a diagram or tell me where they go? its the 3.7 engine K You are not making sense? Firing order??
3, and saves money (mfg. cash) one coil engine' s were banned long ago and its bad actor the Distributor. you can also buy CDI from famous maker.MSD what is on any engine, 13 years old is not known by
...top off the fluid level in the brake master cylinder reservoir. The reservoir is in the engine compartment in front of the driver. Use DOT 3 or 4 brake fluid. Let me know if you have any
...not start engine)Press the accelerator Pedal fully to the floor and release 3 times back to back. Immdeiatly cut key off and remove from switch.This should do it without a problem,,Hope this ...
454 questions posted
Usually answered in minutes!
262 Questions
49 Questions
37 Questions
36 Questions
42 Questions