...turn signal bulb on a 2008 Hyundai Entourage. Looks like I have to take off the whole assembly, which is fine, but how many bolts/nuts are they to remove. There are two 10mm bolts on top side and ...
Question about Cars & Trucks
...turn signal bulb socket, which will be located at the bottom of the headlight assembly. 3. Turn the bulb socket counterclockwise to release it from the headlight assembly. 4. Gently pull the bulb and ...
turn signal bulb 2008 srx Front turn signal bulb replacement 2008 SRX . Jack up car & block . Remove front wheel & front half of the wheel house assemble. There are about 7 plastic pull rivets
...turn signal bulb on a 2008 Camry how do I change the bulb? It looks like I hav eto completely remove the lens itself. If so, how do I do it? Thanks you can see two screws holding this lens assembly, ...
Question about Hyundai Entourage
...turn signals and the brake lights work off the same element or that wire is bad Check the brake light switch. It’s located just behind the brake pedal If the signal flashes fast the circuit is not ...
turn signal bulb on 2008 SRX Cadillac Nope don't need to drop the whole light assembly. I just took the wheel and inner cover off, then the 6 torx screws that hold the light hosing together , replaced
Question about Hyundai Entourage
...turn signal bulb on 2008 cadillac dts My automotive database says you have to remove headlamp assembly to replace bulb. To remove headlamp assembly, you need to remove front bumper fascia. Why in the ...
...turn signal bulb left rear on my 2008 expedition open the back hatch, and i believe there are two srews attached to the cover. take those off and pull the entire assembly off. twist the bulb, pull, ...
turn signal bulb replacement. cant see how to get around the sheathing Some of these are accessible through the trunk. There may be a piece of plastic or fabric behind the tail light assembly that can
tail light assembly. Once out, you can twist the brake light (or reverse, or turn signal) bulb plug, remove and replace the bulb. The Getz uses standard two filament brake globes (1/4 turn to install)
320 questions posted
Usually answered in minutes!
47 Questions
12 Questions
4 Questions
7 Questions
