2007 Ford Explorer Eddie Bauer "39 key ignition" Questions

model, and it program key not clone key, it only needs to insert SBB. It is easy to do, you can DIY, if you don't know about the knowledge of the car repair, you need call for help of locksmith...

ignition switch/steering column truck won't start after installing ignition switch Did you get a key cut to match the sensor for the anti-theft ?

...key it won't do anything. I have had the battery, starter, fuses, ignition, and relays all checked and they're all good. I even tried jumping the starter off and it turned the motor over but ...

...key ignition kit that will fit to my vehicle, but I don't know how I would program it to my vehicle, how can I do this? Usually is explained in the instructions with the transponder

Key is now stuck in the ignition. & I am in real trouble if I can't get this going! I am as alone as it gets here. Miles from people, & I don't know any one here. ((And this is where I

...39;t start? No spark or no gas.  Are you sure the gas gauge acurrate?  When you turn the ignition key from Off to Run, but not all the way to start, listen carefully for the sound of the ...

key turned. same when i try to jump start it. First check your fuse box and make sure you don't have blown fuses. If that doesn't tell you anything, you need to check if you are getting 12V to

...key to far over and now the ignition switch just spins and won't start what do i need to do to fix it? Might be the part on the back side of the lock cylinder that turns the switch broke off. A ...

...2002 ford explorer won't start after we put in a steering column. are you using a different ignition switch and key? they have a transponder in the key and it is specific for the

...the screws again and move it back and forth while holding the key in start position,then tighten screws down again when the engine turns over. Also make sure the rod is in it's correct