2008 Chevrolet Cobalt "put 3 10" Questions

Ad

...3 times, then put it back to park. That resets the oil gauge. let me know if that helps. Taking off battery will not help since the memory is still there even without power. Especially if it uses, ...

Ad

...Put the key in the ignition and turn to run position (do not crank over engine) and let it set for about 10 minutes, repeat up to 3 times, if this still doesn't let you start you will need the dealer ...

Ad

Question about Chevrolet Cobalt

1 Answer

...Put your key in turn it on dont start wait 10 mins remove key wait 10 seconds repeat this a total of 3 times. Your theft light should go out. As long as the light is on your fuel system is disabled. ...

...Put the newly cut Master key into the keyway and turn it to the ON (RUN) position. A "security" indicator light on the dashboard will stay on for 10 minutes. 2. Within 1 minute after the indicator ...

Question about Chevrolet Cobalt

2 Answers

...3 days ago now they are out as well as the tail lights checked for fuze but not sure whitch one is whitch not sure it is the fuse car didn't come with manual 47000 miles on the car just start pulling ...

...3 prongs .l...that's the starter 8) remove 1 13MM bolt holding 2 Positive wires (the bigger one goes stright to the battery) 9) Take off 1 10mm bolt which holds the switched 12v for the starter 10) ...

put your key in the ignition, there begins a constant line of communication between your key's security chip or transponder, to the ignition's lock cylinder, and then to the car's TDM (Theft Deterrent

put in park or neutral to remove key. Ok...By sufficating your engine (and this is exactly what you are doing if you follow the instructions of the first post) it will sall the motor, however what the

Question about Chevrolet Cobalt

1 Answer

...Put the dip stick back. - Apply about 10 psi external pressure to the coolant system, while keeping caps in place. NOTE: It is advised to use the coolant system tester. In case the tester is not ...

...3 Secure the vehicle with jack stands on both sides for safety before starting any work. The pinch welds and the frame are the two best locations. Do not rely on the jack to hold the vehicle up while ...

Not finding what you are looking for?
Cars & Trucks Logo

767 questions posted

Ask a Question

Usually answered in minutes!

Popular Products

Top Chevrolet Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

john h

Level 3 Expert

29494 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...