2007 Dodge Dakota Cab SLT "tie rod replacement" Questions

...tie rod ends Had the same problem about a month ago. Ball Joints were shot and Tie rod ends as well. Look at them and give them a good shaking you should not be able to move them very easily (same as ...

...tie rod ends from the rack and pinion steering once I remove the rubber boot? Since I will be replacing the inner and outer tie rods on both sides all during the same time, what would be the best way ...

...tie rod ends screw onto. The other end fits onto the rack of the rack and pinion. To work on those you will need to remove the rubber boots and loosen the locking washer, they can then be loosened ...

tie rod boot is torn up a little. Any suggestions on what this grinding might be? Thanks! The tie rod end.Those were also notorious for ball joint problems.  With vehicle sitting level, grasp the

...ties into the chasis Just a guess, but I think you mean a tie rod "end link", or a stabilizer "end link". The parts houses have specific kits with all the necessary parts to repair or replace

...tie rod and steering gear. I have to replace both inner and outer. No, there should not be fluid in the boot covering the inner tie rod end. Fluid there indicates a seal leak in the rack. If the boot ...

...tie rod where it connects to the spindle. If that was loose, your wheel wouldn't turn. How long is this rod and where does the other end attach? You need to find out what this is before you drive the ...

...is worn out,Inner,or outer tie rod ends,or a idle arm or such.Best to have it checked,can be dangerous.Also chances are,if it is a tie rod,a aliegnment will be needed after part,or parts are

...tie rod end and the seal you mean is the dust boot on the tie rod end, when you buy a new end it will come with a new boot. but if you mean the front axle shaft it should not cause the tire to wear ...

...tie rod ends and ball joints need replacing do these first before getting the tracking done. After replacing these don't assume it will correct the alignment automatically as you would have disturbed ...