2008 Chevrolet Malibu "change rear side" Questions

cannot locate which fuse to change for the rear tail lights. what is it labeled on fuse diagram? try the main fuse panel under the hood on drivers side. also one on passenger side and driver side dash

...bleeding each side to remove any trapped air...be sure to recheck brake fluid level after bleeding...you can bleed at the brake line connection to each side...on each rear caliper...Hope this

...rear turn signal blinks at an extremely quick rate compared to the right side. Tried changing the front turn signal bulb and did no good. Could it be the rear bulb is messed up? A dead bulb could do ...

...rear are brake shoe type brakes. So far everyone i talk to has told me to change the rotors and that should solve the problem. Well on saturday, i went ahead and changed both front rotors, both front ...

...change slightly on the whinnying. What other bearings are in the drive train to react this way? the rear wheel bearings.If you did not torque the front bearings properly they will make the same noise ...

need to change fuses where is the fuse box Some lights and rear defroster not working should be under driver side under dashboard

rear right wheel area while the car is rolling under 5 to 10 mph! help it's so loud sometimes i can hear it over the radio! any ideas? It might be a warped brake rotor. Does the noise change depending

...change my rear shocks Look under the car - you'll see 2 long metal rails ( the frame rails) . Support each side with a 2 ton minimum jack stand fully extended approximately one foot ( 12" ) in front ...

...rear of the car. you will need some good ramps and or some car jack stands to get to it.if you are uncomfortable with attempting this just take it to any oil change shop and most will do the job for ...

...brake reservoirs are full? If they are, then try bleeding. Start at a rear tire and move to front, with the driver's side being last one bled. Check carefully for any signs of brake lines