2008 Ford Taurus Sedan "link pins" Questions

...is what keeps the piece of flat metal on the pins? Every time I put the actuator on, my piece of flat metal falls off there should be a clip on the lever that holds the link on--is that

...this problem. All I know is that it makes this clunking noise when I drive it Ivan when it's idling. Is the noise while you are driving on rough surfaces? Could be the sway bar link pins

...slotted nut. Discard cotter pin and nut 9.remove tie rod from knuckle 10.Remove stabilizer bar link nut, and remove link from strut 11.Remove and discard lower arm-to-steering knuckle pinch bolt ...

...pins at the data link connector (top row second from left and bottom row second from left). SCP voltage will usually range between 4.5 and 5.0 volts. If there is no voltage present at these pins when ...

stablizer sway bar link ball joint is broken (boot sleeve is torn) need find propper instructions for removal and installation to fix this problem Remove the front wheel. Loosen the jam nut on the tie

have a 1997 Ford Taurus GL. 3.0 Liter. 230,000miles. It has been a very reliable vehicle over the years until now. Two weeks ago it began to stall while driving. I made it home and parked in the ...

pins and the lower instrument cover from the instrument panel reinforcement (at the passenger-s side) Console finish panel Under the steering column, 2 instrument panel brace screws, the courtesy lamp

...pins on rear speaker panel and lift out of the way. You have to be concern mostly of the bolts on the bottom of the struts, they tend to get rusted and might break off if you are not careful. Also ...

...FORD TAURUS WONT START ALL IT DOES IS CLICK? Hi Alfredo:Check this starter diagran...Zoom Image link: 0900c152/large/0900c1528025fe5a.gifSOLENOID REPLACEMENT Remove the starter motor, as

...pins using a pair of slip joint pliers if necessary 3. Remove any other accessories that might interfere with the removal of the camshaft sensor like wiring harness, spark plug retainers or engine ...