2008 Nissan Sentra "engine control unit located" Questions

...the new 2008 nissan sentra has and where they are located? There is 1 ecm(electronic control module), 1 tcm(transmission control module), and a few other control units. The ecm is in the engine

...how do you remove it? do you mean the speedometer or the engine RPM ----gearbox??? if its the engine RPM their is no sensor as it reads from the ECU unit which is controling the engine ...

...Engine Control Module I can't find the ECM under the hood of my Sentra. I want to replace the defective unit with a used ECM from the scrapyard. Why would a 6 year old vehicle need a new ECM? If you ...

...engine hesitation (and other problems), it is in most cases the idle speed control air-bypass valve and or throttle valve and upper intake, these area's get full of gunk and combustion residue over ...

...engine hesitation (and other problems), it is in most cases the idle speed control air-bypass valve and or throttle valve and upper intake, these area's get full of gunk and combustion residue over ...

...Control Motor (IAC) Low compression (170 psi + is OK) Start cleaning and repair these trouble spots and see is there any improvement. ==== For more advance DIY'er then you may try this. Use a can of ...

54-56mm). Tighten the control rod bolt to 10-13 ft. lbs. (14-18 Nm). Tighten the support rod bolt to 26-35 ft. lbs. (35-47 Nm). Start the engine and check for leaks. Make all the necessary adjustments

engine hard starting, idle poorly, hesitate or stall?... If the CEL is flashing I'll send the procedure to identify the trouble code/codes that the Electronic Control Unit (ECU) has stored... Guru....

engine-the blower motor for the climate control is located in the plenium, inside the passenger compartment, above the passenger side riders' feet. It is probably not an overly difficult job to do

engine control module) controlling fuel mixture, timing and emission management systems. While the engine is surging the ECM is "hunting" by adjusting the fuel mixture and timing. These adjustment are