Question about Ford Fusion
relay port, the compressor and fan come on and cold air is produced through the vents. What could cause this? Sounds like a bad heater control unit, or bad control module. You are bypassing the switch
where is the cooling fan relay a 2006 ford fusion with a 2.3 engine its under the cover above the radiator follow the wires from the fan to the relay.
...in the system. You will need to figure out what is puting power to the relay to make the fan turn on. Hope this helps narrow it down a little... It must be mis wired because it is controlled by
...fan goes right on after 5 secounds after the car is on and wont goes off till the car is off again Two things can cause this - defective sensor for coolant temperature or defective relay after the ...
06 fusion cooling fan will not cut off Can be stuck fan Relay.
...fan so you dont run your battery down while you park it, put it back in to drive though, just till you get the new sensor. replace the temp. sensor in the side of the radiator or replace the temp .; ...
...light is on get read out if on and go on from that point n see any short to ground from inside your car down to d fan relay ur last check point would be ur computer grounding internally Good ...
Question about Ford Fusion
...fan would not longer work on ac. Check the fuse in the fuse block. 2011 Ford Fusion. My heater/AC works on and off . I have checked my fuses and relay they are all good. Wondering if its the ...
relay compressor will come on. 4. When compressot come on high side when over 350 psi. 5. Fan was not on 6. Unable to locate low side recyling switch. 7. Can high side recyle switch cause fan not turn
...seems to be o If the AC fan does not come on, it is probably the relay, switch, or fan itself. If it comes on but is not cold, it could be the relay, compressor clutch, or the climate
429 questions posted
Usually answered in minutes!
750 Questions
135 Questions
91 Questions
53 Questions
48 Questions