2008 Volkswagen Beetle "alternator belt vw" Questions

... pull the alternator towards the outside of the loop the belt makes, then re-tighten the alternator bolts. If you can't get enough tension through the adjustment you'll need to replace the belt. Bill ...

...the alternator? you have to remove the serpantine belt and then the alternator has 2 bolts one top one bottom remove both it slides out put new in put new serpintine belt on good to go 2 hour ...

...not found a routing diagram start at crank goes around crank pulley and ac compressor then inside the idler back out around alternator theninside tensioner belt will almost touch itself between ...

...alternator . Undo 3 bolts on the belt tensioner and remove that. Undo the electrical connections on the alternator. Undo 2 bolts holding the alternator on to the bracket and pry out. Here's where I ...

...belt routing for 2.0 l woith ac The serpentine belt routing diagram for 2000 VW Beetle 2.0L with A/C system: CS = Crankshaft Gen = Alternator T = Tensioner AC = Air Conditioning WP = Water ...

...read" :-) My '96 Passat TD (not a TDI) overheated last week and the battery light came on - it was a failed alternator belt which drives both the alternator and the water pump. Hope this helps,

...like the alternator belt is loose. Re-tension it then replace the belt as soon as possible as its likely to have been put under a lot of strain since it was slipping and causing the squeeling

I am looking for a belt diagram for a 2009 VW Beetle 2.5L. I need a diagram for both AC and alternator i have them..send me email address and i will send them

belt tensionner (3 13mm bolts). The alternator has 2 13mm bolts remove those then pry it out. the 2 alternator bolts have steel bushings that hug the bracket so a little force might be needed. If your

...alternator driving belt and ventilator fan !!! 2. If the thermostat is good the hose must be cold until the water temp indicator reach almost 90 C deg. 3. The thermostat opening temperature is 87 C ...