2008 Jeep Wrangler "iod problems" Questions

...on when i put the key in the ignition, except for the clock. any suggestions? try removing the IOD fuse in the fuse block for a minute then reinstall it. will reset the ...

...problems. Cannot recall hearing relay whine / hiss in all my years. Hey Tim take a look at this, will this help ? SUBJECT: No Engine Crank Or No Engine Start Due To Electronic Lockup Of The WCM / ...

2000 caravan 3.3L intermittent IOD resulting in dead battery. Vehicle driven 1 or 2 times a week, fuses, relays, starter, alt, ign sw, cluster, all seem ok. problem is very intermittent as stated ...

...on odometer ok i have readed alot on the word fuse on the odometer mostly people says that its the iod dome light fuse not working but on my car all 4 doors dome light connection and wires are ...

...on the truck works but the radio and domelights,I have checked the fuses they are good It's the IOD fuse. Trust me, I just fixed the exact problem on my '98 not ten minutes ago. The fuse is ...

...from door or remote http://en.allexperts.com/q/Chrysler-Repair-807/f_4572118.htm Simply remove the IOD fuse for about ten seconds and replace it look at your fuse Pulling the IOD fuse is only a temp ...

...problems as well had this issue before and ended up replacing power door actuator as magnets would not dis-engage to allow door to be opened even manually need location of the Iod fuse need ...

I have a 1997 dodge ram with a draw on the battery. when i pull the iod fuse the draw goes away. any help? You will have a small draw on the iod fuse circuit because the Ecu keep alive memory runs on ...

...the wires that go to that sensor break. reconnect those wires and problem solved Try removing the IOD fuse to reset it. My speedometer and tach were not working after putting in a new battery. ...

1999. Why does the 15 amp IOD fuse keep blowing? 15 amp IOD fuse was replaced 2 months ago and now blew again and cluster panel and radio out again...replaced fuse but as soon as I start engine it ...