2008 Jeep Commander "power going washer pump fuses" Questions

...power and the other ground, so when you hit the washer button, if it lights up, you need a new pump! if it doesn't it is most likely in the switch, cause there are going to be other functions you are ...

...power going out of switch to the pump-key on and pump switch on. If power on both, the wire from switch to pump must be broken. Run a new wire. If power into switch but none out-switch is bad. If no ...

...power is going to pump,if so then pump is at fault,if no power,thenwiring could be short somewhere to fuse box.Also check your washer hoses,that they are not kinked or came loose.Pump could just be ...

...switch and use the probe end of the test light to check the wht/grn wire if it lights, you have power and ground. may have to access the washer bottle and pump from under the car. Hope this

and where is the fuse location of the fluid pump? 1998 Chevy Tahoe Washer pump gets its power from the connector on the wiper motor (red wire). Fuse is WIPER fuse #11 25A in instrument panel fuse box

...going to it, power and ground. Pull out your reservoir and dosconnect the wires going to it. Connect a meter to the power side and mesaure for power (have a friend push the washer button). If you are ...

...the washer. If the wire has power, it is the motor or the ground for the motor. If there is no power to the pump motor, check the washer switch. There should be a hot wire going to it with the key

...power to the washer pump through circuit CRW14 (BU/WH) and ground is provided to the washer pump through circuit CRW12 (GY/OG) and the rear wiper motor. If rear wiper wash is selected, the rear wiper ...

power when key is on and washer switch on, the motor is bad, or sometimes you have to go a little further and find a ground fault. If there is no power on any wire at the pump connector, you will have

...power TO the washer pump itself, when the wash switch is engaged. If you've eliminated all of the above, go ahead and replace the washer pump. Find it in the resevoir, disconnect the wiring harness, ...