2008 Chrysler Pt Cruiser "motor 2 turbo" Questions

...motor so I can get to the crankshaft sensor. Thanks! You may sneak it out with small fingers with out pulling out the starter. If starter removal is required,Just unhook the battery cables,Remove the ...

...2 or 4 out of 6 cylinders. Do compression tests.. and hope you don't have damage to piston head too.. You're probably going to need valve job with new valve stems. If you're lucky, and I'm wrong, it ...

...2.5L diesel. Look under the hood and see if you can find the engine or emissions tag and get me the engine family code and I can tell you what motor is in it. mike P.S. You could also clean the oil ...

...noise went it starts 2 boost up its kinda coming from above the starter motor check pipe connected to turbo it maybe split/also turbo unit itself may need replaycing/fan inside turbo maybe ...

...motor leads and the negative battery cable. Fig. 1: Unfasten the nut retaining the starter cables . . . Fig. 2: . . . and remove the starter cables Fig. 3: Unfasten the starter retaining bolts . . . ...

...2 is this, if youre looking for serious power with an engine that has been made perfromance stable(built to handle the difference in compression ratios and ability to take more rpms), either will do. ...

...2) How the heck do you get to the spark plugs?..iv tryed to get the ones on the left and there impossible to get to only way is by remobing the motor oil can where the pistons are at but i sure as ...

motor running until the turbo slows and cools down then shuts off. If it has it will be about 2-3 minutes. Another reason that diesels keep running is that there is oil getting into the air inlet side

...2 muffler. I have been developing the car for vintage racing and just rebuilt the motor with these mods. Only 500 miles including one racing weekend since the rebuild. Mechanic adjusted the valves ...

...Motor (fan was bad..would barely turn) 2. Radiator Cap (very small leak) 3. Thermostat 4. Temperature Sensor 5. Relay (in fuse box) 6. New PCM (computer) When car started after last replacement (PCM ...