Question about Chevrolet Uplander
...the serciut board that the bulb gose into. Shorted wire or needs new socket both easy to check Pull out socket turn on light apply volt meter 5o back of socket check for 12 volts if has replace ...
...wire harness, then it's going to be the bulb it self, but make sure your checking the right 12 volt terminal at the plug. There should be three terminals there, there is a ground, 12 volt low beam, ...
Question about Toyota Cars & Trucks
...12 volt led light burned out.. all bulbs LED too don't last.. Find the 2 wires usually Black and red and check for 12 volts with the alarm set and if you have 12 volts,. you need to go to radio shack ...
Question about Chevrolet Uplander
...12 volts at. The meter should read no/low/minimal resistance. If you measure high resistance, then you will need to locate the corrosion or open/broken wire between the bulb connector and grounding ...
...12 volt wire at / between the common passenger 12 volt brake light wire in the harness to the center contact on the brake lamp socket. My suggestion is if the brake lamp wire is ONLY for brakes - not ...
Question about Cars & Trucks
...12 volt system uses less current than the 6 volt system, so there should be no problem with wire gauge. IMPORTANT: If the original system is POSITIVE GROUND instead of NEGATIVE GROUND, you will need ...
Question about Saturn Cars & Trucks
...any other possibilities ? bad ground wire for the light check both sides of the bulb as one will be 12 volts and the other considerable less because of the high resistance of the filament of the ...
Question about Cars & Trucks
12 volts for each bulb. * A series CKT would mean if one bulb failed, they all fail. (like old Christmas lights, you have to check them all to find the bad one.) * Wattage of bulbs will have an effect
bulb (9007) and it still womt work Using a multi-meter, check for 12 volts when the light is supposed to be on. If 12 volts is not present, you may have a faulty terminal, faulty wiring, faulty switch
Question about Cars & Trucks
...wire to the battery and the charge light or volt gauge ( auto electrician can advise here ) starter motor will have to be changed to 12 volts and you will again have to get the replacement unit from ...
458 questions posted
Usually answered in minutes!
500 Questions
457 Questions
25 Questions
18 Questions
8 Questions