2007 Kia Sportage 4x4 V6 "wire 12 volt motor" Questions

...wire plug. Unplug it. Connect a 12 volt test light across the 2 wires.Turn on the rear wiper switch with the key on + if it lights up, you need a new motor. If it doesn't light up check your fuse and ...

...12 volt light can be simply made as a voltage tester. There will be a 3 to 9 volt current through two wires for the fuel level Guage so don't confuse this with the pump wires which are in the same ...

12 volt battery's I'm installing dual 12 volt battery's in my motor home. How are they wired. pos to pos and neg to neg for 12 volt but if your system is 24 volt thats a different story it will be pos

...12 volt system uses less current than the 6 volt system, so there should be no problem with wire gauge. IMPORTANT: If the original system is POSITIVE GROUND instead of NEGATIVE GROUND, you will need ...

...to the blower motor for the presence of 12 volts. Check the blower motors ground wire. If it's getting 12 volts and not working, it's time to change your blower motor. If not, check for a blown

...the starter that has 12 volts all of the time from the battery. A smaller wire will have 12 volts only when the key is turned to "start". If you have these and a good ground, the starter motor is

...12 volt reading.If you are getting 12 volts then your wiper motor needs replacing If your not getting 12 volts then the switch is faulty replace it.Good luck. Check the wiring from wiper motors to ...

...12 volt wire to positive side of blower motor blower ran fine. I checked for voltage on blower resister, no voltage. I checked for voltage on blower 12 volt wire 12 volts present. I automatically ...

...12 volts...At the wiper motor assembly connector...Check Pin A Purple wire...Pin B Dark/Green.. Turn wiper switch to low and measure both pins...Do the same with switch on high...If +12 volts is not ...

...12 volt 43# thrust unit can I replace it with a 24 volt 70# motor ? Is the shaft and head wiring the same ? If you don't supply 24 volts to the motor, it won't run. You'll have to read the specs on ...