Dyson Ball HEPA Upright Bagless Vacuum - Iron/Satin Yellow "beater bar problems" Questions

...beater bar side up. Remove the cover base plate that surrounds your beater bar. It's held on with either clips or screws, and usually "hinges" toward the front of the vacuum to release when the ...

Beater bar not working on Halo vacuum I've had this problem before, but usually the beater bar wasn't working because the door where the hose attaches isn't closed properly and so the suction isn't ...

...beater bar runs for a little while then quits, I've cleaned the bar by removing the bar to clean the dirt,strings and ect and also took the end of the bar off and cleaned it also It's good that you ...

beater bar is not engaged. When you tilt the handle back, the clutch engages and the beater bar begins to turn. There are two likely possibilities for the "screaming noise". First, and most likely, is

...beater bar in my machine will not rotate just makes a squealing noise It could be that the bearings in the beater bar are shot or are full of dirt or pet hair. A new beater bar will fix the

...beater bar making noise beater bar makes noise-- like rattling. Bought a new beater bar, replaced it. same problem-- must not have been a beater bar issue! Hi there,I'm sorry to hear you're ...

beater bar does not move DC07 beater bar does not move this is a common problem it moves on air flow, the air flow may be good but there is stuff wrapped around the ends of the beater bar, disassemble

beater bar is not turning. The bar is free of hair or strings, the motor is working, just the bar will not move If the motor is working then check the drive belt. There's a door on the right hand side

...beater bar (brush) I have found that the belt for the DC17 is about .100" too wide to properly fit around the cogs on the beater bar, I took a sharp pair of scissors and cut of the edge and it seems ...

...beater bar on my Dyson DC14 All Floors Bagles vacuum cleaner doesn't turn. There is no hair or thread caught up in it. All air-flow areas have been checked and there are no blockages that we could ...