Logitech G51 5.1 Multimedia Surround Sound Speaker System (6-Piece) "board speaker" Questions

...speaker...No voltage...Fuse on board is good....Is the board bead? If so can I purchase one? yes bad bord so cheap on these u can kick bass out like u wanna best bet referb kilspsh on ebay 70 bucks ...

...board, inside of your speaker system, time to RMS or use the warranty, if you register your product, this could be easy. Some boards , depending on energy at home voltage, etc, can be damage, and ...

...because the store will replace a new for defective product..or you can go to the web site of the brand of your speaker if you intent to buy the main board you can order trough the online

...speaker. also check if you dont need to configure the software that comes with your sound board, sometimes you must configure it manually. also check the sound board manual and recheck cable ...

...board or speaker issue Yes, it could be mother board or bad speaker wire. Or get another sound card and have someone install it for you and load the driver. again, If you have the driver for that old ...

...speaker but can here sound from them. You could have an earth loop which causes a hum/buzzing sound. Is your computer and powered speakers plugged into different mains? Connecting amplifiers and ...

...speaker board. The wrong power supply got connected and now the speaker doesn't work. Is there any way to troubleshoot and possibly fix If you can get the speakers open, check for blown capacitors or ...

...speaker is making buzzzing sound? You may have an earth loop problem.This is caused by connecting your computer to a mains outlet and the powered speakers to a different mains outlet.If this is the ...

...First things first: 1) It is a module inside, that conduct direct energy to the resistors on the board for speakers, may be is fried. you have to take it to the repair shop for fix this or RMS

...board in the opposite speaker. Can anyone assist? It isn't the wiring as I checked that back to the pin connector. Could it be the connector? A resistor? The board itself? Any help would be ...