Question about Maytag Ovens
...to reach temperature and smell of gas That is a very common problem. Normal wear and tear. You need a new hot surface ignitor. Maytag oven repair in orange county, ca appliance repair orange county, ...
...hot enough to ignite the gas).As far as checking them you don't actually need a clamp on meter (though it is the preferred method) you can also ohm it out to test it as follows... You should ...
...hot surface ignitor systems, (even if the broil does, it's a separate ignitor and used much less so subsequently doesn't tend to need to be replaced as often) is the ignitor itself is at fault. Try ...
...hot, but the gas does not come out and light. We did not have this problem prior to a power outage that lasted for 15 hours. I dont know if the problem is related. The most common problem for gas ...
...hot surface glow ignitor (HSI) does not glow and all control selections and settings on the front control panel are set correctly, chances are the HSI is burned out. Replacing the HSI part is likely ...
Question about Kenmore Ovens
...hot surface igniter is used in modern gas oven burners to open the gas valve and to ignite the gas. As the igniter draws electric current it will heat to a high temperature and glow, as well as cause ...
...hot surface igniter does not glow you should first verify that you have voltage to the circuit. This is a live voltage check and should be performed by a qualified person. If voltage is lost at the ...
...hot surface ignitor is likely the problem and cannot be by-passed or manipulated into functioning. However, if the boiler has the same ignitor one could in theory swap the ignitor`s ( very carefully, ...
...hot surface ignitor for the bake burner is likely the problem. Here's what you can try to varify if it's indeed the ignitor...if you're mechanically inclined. **Turn off the breaker or unplug the ...
62 questions posted
Usually answered in minutes!
140 Questions
54 Questions
56 Questions
27 Questions