Frigidaire FGQ332ES Gas Dryer "drum turning troubleshooting" Questions

...turn for about 5-10 seconds and then the drum will stop turning. After 5-10 minutes the drum will come back on. Go to: RepairClinic.com to troubleshoot your appliance. You'll need the make & model

drum is turning. Can you help me troubleshoot and repair this problem? Thanks sounds like your drum glides/rollers that the drum rests on in the front are bad remove the top cover then the front cover

drum to check it out? Model # 110 606 12990 Serial # MK2148794 Thanks Just a general troubleshooting guide for your washer! hope this helps!! PS don't forget to give me a rating if this helped!! Thank

...drum is not turning then i would say the Belt has come off the rear of the drum and needs to be checked firstly. If there is a fault code then it could be the thermostat has tripped out its safety ...

...troubleshooting tips for you ok The drum of the dryer is usually turned by a motor-and-belt assembly. There are two very clear signs that the belt is malfunctioning: You can easily spin the drum by ...

turning on everything seems to operate properly. Is there a resettable or replaceable thermal switch that may have tripped? Maybe something on the controller board? Thanks for any troubleshooting tips

tension and remove the belt. Try turning the drum by hand to make sure the wheels that it sits on are not bound up. If all that looks good then I would say the motor is bad. Hope this helps. Good luck

...drum is not turning smoothly, it can cause the dryer to stop prematurely. Here are some steps you can take to troubleshoot the issue: Inspect the drum support roller: Check if the drum support roller ...

...drum does not turn and no heat. Time does count down and all the lights are on but no action. There is no error code either. I can not find anything in our manual troubleshooting section so I have no ...

...Drum still turns but no heat where do i find the heater Hi, If you have a gas dryer. The most common problem with a gas and no heat is the ignitor going bad... Here is a tip that I wrote about that ...