...window AC unit I need to open up the AC unit so that I can re-attach the cord. Do I remove the main housing or the front cover to do this? The main power connection is typically behind the panel with ...
window ac is blowing water There is a drainage hole on the outside of the window unit. It is blocked. Remove power from the window unit. Unclog with a wire coat hanger.
Question about Frigidaire Heating & Cooling
window units normally have a sensor thats attached to the front of the indoor coil. This controls the thermostat. I usually pull this sensor away from the coil because it stops cooling before the room
...ac or the sleeve. Hi, The drain holes in the bacl are plugged with dirt... pull the A/C out and check for the blockage and remove it so that the unit will drain properly. The drain holes are usually ...
remove the unit from the wall or window, and wash it down real good with a hose being careful not to get the electronics wet. If not and the unit sound different than it did before, it's probably time
Question about Frigidaire Heating & Cooling
...window ac? I am trying to clean my ac. Is the vent removable? That unit appears to be pretty old. No manuals. I believe the outside cover will come off by prying around the edge and pulling towards ...
...remove the unit from the window in the winter. Thanks for your help Most of the AC Unit lately are not made to drain. So when you have water collecting inside the unit, the condenser and the ...
...remove all the dirty leaves. How do i get this done ? With my Maytag window unit, I just unscrewed everything on the casing until the front part could be popped out/unclipped then cleaned out the ...
...AC 10,000 btu-not cooling very well Purchased in 2006 - running fine until this year - not cooling properly have set to 60 degrees - went thru all the troubleshooting and everything is ok. Just not ...
28 questions posted
Usually answered in minutes!
90 Questions
61 Questions
42 Questions
37 Questions
47 Questions