Question about Hotpoint Washing Machines
machine washable wool, woolen blankets..... 1.5 kg 1 hour 15/25 mins Fast Spin H...(Wool mixtures with cotton or rayon.....2.5 kg) J 30* Silk, printed acetate.....3kg 55 mins/1 hour 5mins... Slow Spin
...1:02 machine runs and timer counts down to 54 mins. then resets to 1:12 mins. which inturn adds approx. 18-20 mins to wash cycle why the reset?? I had a similar problem with ours and had a repair guy ...
Question about Beko Washing Machines
washing machine gets to 2 mins and will keep going I have been at work 8 1/2 hours after starting the wash to find it is still running with 2 mins to go. the cloths are still very wet. Thanks Wmy 9048
...washing cycles usually take 45 mins to 1 hour on normal machines. Has my machine got a fault or are the wash cycles supposed to be so short? Look for wash cycles in your users'manual. It is best the ...
...1 min. spinning and rinsing for another 30 min your using way to much soap during that whole 1 minute cycle it is detecting suds and trying to rinse the cloths further cut way down on the soap here ...
washing machine does not spin, Bosch WF024564GB/01 jumps from 11 mins to 1 min . no blockages drains and fills, pumps run, belt fine, is this a control module fault ? check the brushes on the moter
1 min left for like 20 min while it does another rinse and spin Hi, This may happen if using the Super-eco program. It is designed to extend the washing time / cycle, but is less intesive in rotations
...washing on at a 60 degree wash for 1 hour 40 mins. Went back to machine several hours later, there was tiny amount of water on floor and machine had water in it but the wash had not progressed any ...
...1 minute left and it was spinning and draining. I cancelled and checked the towels, shirts, etc and they were still dripping wet. This was not a really big load. I hit the drain and spin for 12 min. ...
Question about Washing Machines
...with 1 min to go. After switching off, the machine still says 1 min left regardless where I turn the dial check for the water vapor in the rotor switch, may caused corrosion causing this to
29 questions posted
Usually answered in minutes!
522 Questions
457 Questions
351 Questions
272 Questions
222 Questions