Brother CS6000i Computerized Sewing Machine "needle holder brothers" Questions

needle holder by on brother sewing machine xl 5030 The needle clamp pin is inserted before the screw is inserted. This allows pressure to be made on the needle. The needle holder is held on by a screw

...bobbin holder to clean, when I replaced it the needle hits the holder. Is holder supposed to turn? Hi, sounds to me like you haven't refitted the bobbin correctly Regards ...

...needle holder came off rod and can't get it to stay on. Now know about screw and wire which i don't have. WHERE can i get a replacement. Vonnie Brother sewing machine XL-5012, needle holder ...

needle keeps dropping out try tightening the screw on the needle holder and if that doesn't work you may have to have the needle holder replaced at a sewing machine shop

...to the left to release the needle. Insert new needle, with the flat side to the back of the machine. The manual shows a needle holder tool, but fingers work just as well as do a pair of

...holder and noticed the needled goes in the hole, but hits the side when it comes back up. When I reverse it, the needle hits the metal under the bobbin. The needle and the hole do not match up. try ...

needle is in the highest position before you try putting the bobbin holder in. The bobbin holder has a metal 'finger' which fits into a 'slot' in the housing and it only goes in if you have the needle

...too try sewingpartsonline.com whole part that has needle in fell off, needle is still in situ but its not obvious how to get the whole holder to stay on pole, it goes on and falls right off

...needle holder came off rod.n needle holder assembly fell off rod.need to know how to put back on rod. The needle holder has a screw right above the screw that holds the needle in place. It really ...

...do not have the foot down when you are threading the machine,as this stops the thread from going through the needle tension holder. Can you buy embroider memory cards with out down loading on your