...power cord, if the power supply is a power cord with electrical connections at each end. Figure 1: Power cord The product uses a power module, if the power supply is a power cord connected to a power ...
need power cord need used power cord - bought used d7460 - no cord You can get the power cord from any electronic or computer store near you or you can also get a second hand power cord from EBAY....
Question about HP PhotoSmart Office Equipment & Supplies
...power cord I was trying to use. Some power cords have fuses in them that can be bad. Is your cord a two piece with a box? Or a single piece cord? If its a single piece cord, I would question that it ...
Question about HP PhotoSmart Office Equipment & Supplies
...power cord from the back of the HP All-in-One. Plug the power cord back into the HP All-in-One. Turn on the HP All-in-One by pressing the On button on the HP All-in-One. If the issue persists, then ...
...power cord from the rear of the printer and holding down the power button for 30 seconds. If the above doesn't resolve the concern, then try the step 2. Step 2: Perform a Full Reset of the HP ...
...power cord from back of the product. 3. Disconnect the power cord from the wall outlet. 4. Wait at least 15 seconds. 5. Connect the power cord into wall outlet. 6. Connect the power cord to the back ...
Question about HP PhotoSmart Office Equipment & Supplies
...power cord from the back of the HP All-in-One. Wait 15 seconds. Plug the power cord back into the HP All-in-One. Turn on the HP All-in-One by pressing the On button.SOLUTION 2: Reset the power module ...
power cord at the back of the printer. Press and hold down the power key for 30 seconds then release the key and plug the power cord back in. --> if this doesn't work please proceed to the next
...power cord from the product. Disconnect the power cord from the electrical outlet and wait 10 seconds. Reconnect the power cord directly into the electrical outlet and check for the following. Make ...
Question about HP PhotoSmart Office Equipment & Supplies
...power cord, green power light on cord is lit, replug cord and the printer starts to power up, then gives an error message of improper shut down n powers off, then the green light on power cord goes ...
462 questions posted
Usually answered in minutes!
1,869 Questions
1,438 Questions
900 Questions
484 Questions
508 Questions