Question about Lexmark X Office Equipment & Supplies
...ALL exterior peripheral cables that plug into scanner and printer base. Pay close attention to all pins on these cables and ensure none are bent. Put all cables back carefully ensuring to properly ...
Question about Lexmark X Office Equipment & Supplies
scanner pin code I have recently purchased the above printer and it did not come with any user documentation (installation via dowload from lexmark site). I therefore do not have a pin code to use the
Question about Lexmark X Office Equipment & Supplies
...scanner asks for pin code and won't scan without it. Hi there! Up to a few days ago I could easily scan documents to my computer. However, I tried to scan a document. However, after after I selected ...
...scanner code (pin ?) to scan. Here are the steps from Lexmark Support: Step Action 1 Make sure the printer is configured to scan over a network. 2 Load an original document face down on the scanner ...
...it. I checked all the cords & lines already. Please help if its a buzz you probably have a loose pin thats not attached probably if its more hissing like than you have a leaking capacitor that has ...
Question about Lexmark X Office Equipment & Supplies
...scanner & control panel by disconnecting the 3 ribbon cables Then, you will need a screwdriver (philips head). remove the screws (about 4) from the inside housing cover. After you have this cover ...
scanner won't work do to needing twain I have a Lexmark X3500-4500 series all in one. I have been troubleshooting all day, and I can't seem to find a solution. My imaging studio will not let me do ...
Question about Lexmark X Office Equipment & Supplies
...scanner table assembly off the rest of the printer. Look for a steel spring about 3 inches long...remove this along with the round base of the hinge which may have broken off and remained down inside ...
...scanning mechanism When you install a new Cs2520 you have to remove the three tapes holding the pins for light source units 1 and 2.(scanner) To secure the scanner you would have to reinsert
...connector holes are round in shape and not oval. If the holes are oval-shaped, insert a small pin to reform the hole to mostly round. Reseat the scanner cable connection to mainbody. hope that ...
150 questions posted
Usually answered in minutes!
1,487 Questions
1,353 Questions
1,277 Questions
961 Questions
741 Questions